Standard Pressure Clamps

2 products


  • Tri-Clamp Single Hinge Clamp 1.5-inch

    Tri-Clamp Single Hinge Clamp

    Tri-clamp/ Tri Clover Single Hinge Clamp BVV™ recommends tightening all Standard Pressure Clamps (Non-High Pressure) to finger tight and then use either a screwdriver or wrench to tighten them approximately 2 full turns to achieve the torque specified on the data sheet. All tightening should be accordance with the data sheet.  It is not recommended to overtighten the clamp and bottom it out as this will cause the gasket to be over-compressed and put too much tension on the clamp threads, which could cause it to fail.  Overtightening can also cause stretching on the clamp reducing its operational effectiveness.  Torque Specification Data Sheet Specifications: Mounting Type: Hinged (The 1.5" Clamp is Double Hinged) Material: 304 Stainless Steel Bolt Material: 304 Stainless Steel (3/8"-16 Bolt) Nut Material: Brass (5/8 Wrench Size w/ 3/8"-16 Thread Size) Connection Type: Tri-Clamp

    $11.09 - $108.16

  • Sale -54% 3 Piece Heavy Duty Tri-Clamp 304SS Shop All Categories BVV 1.5-inch

    3 Piece Heavy Duty 8" Tri-Clamp 304SS

    3 Piece Heavy Duty Tri-Clamp/Tri Clover 304SS This 3 Piece Heavy Duty Tri-Clamp is made out of 304 stainless steel and has a 3 segment locking function allowing even pressure around the connection point gasket so it does not bulge out in a certain direction creating a better overall seal on the system. This clamp will fit a standard 8" tri-clamp connection    

    $194.14$90.13

Login

Forgot your password?

Don't have an account yet?
Create account