MFR: AlumiliteSKU: 20500
✔ Free Shipping On Orders Over $200!
✔ Flat Rate Shipping On Orders Under $200!
*some exclusions may apply
You will earn 0 points for this purchase.
Alumilite's High Strength 3 silicone mold making rubber is our most flexible silicone mold making rubber and is great for making molds of parts with deep undercuts or negative drafts. The High Strength 3’s flexibility and high tear strength give it the ability to reduce seam lines by making one piece molds rather than multiple piece molds where seam line removal is critical. The High Strength 3 is a tin base silicone and cures against all different types of clay and substrate. The tin base silicone is a condensation cure and therefore temperature and humidity may affect the cure speed of the rubber. The High Strength 3 has a low viscosity which does not require degassing (always recommended when available) and will pick up the exact detail of your original. Use Alumilite's Rubber to Rubber mold release or petroleum jelly when making 2-piece molds when using the High Strength 3 rubber due to it's extremely high tear strength.
Alumilite's High Strength 3
|Mix Ratio||10:1 by WEIGHT|
|Open Time||45 mins|
|Demold Time||12-18 hours|
|Mixed Viscosity (cps.)||15,000|
|Shore A Hardness||8-10|
|Linear Shrink (%)||.3|
|Tear Strength (ppi)||115|
|Tensile Strength (psi)||400|
|Temperature Range (F)||-67 to 395|